L1409 38mm 'Bare Wood' Spacer Ash FSC 100% Frame Moulding

- Glass Spacers can be used with any moulding with sufficient rebate depth

- Useful as a slip or fix to the bottom of moulding to increase the useable rebate

- On Chop Service, spacers are always measured to the back edge, to fit into the rebate of the corresponding moulding

Cutting: Ash is a hard wood and can only be worked with on professional framing equipment. For the best quality cut, order this moulding mitre cut to size on our Chop Service.

Joining: Joining Ash takes some skill - because underpinners displace the timber fibres as the v-nail is inserted, getting a tight join on dense hard woods can be a struggle. If you work with these timbers, try the Hoffmann Frame Joiner, which routs a slot for a dovetail key. Once tapped into place, the key pulls the corner tightly together.

Finishing: Takes all finishes well. Best finished with a wax or stain to show off the distinctive grain. Take a look at our wide range of finishing products.

Ordering bare woods: We take care to match the grain and colour between lengths as far as possible but it’s important to be aware that bare woods vary more widely than finished woods. They can also be a little more prone to warping and twisting.

Ordering chevrons?

As this moulding is particularly narrow we're unable to supply the usual chevrons. Instead we'll send a 190mm sample piece.

Ordering information

- Order in metres, we will round up to the nearest full length.

- Lengths vary between 2.3m and 3m.

- Approximate box quantity: 198m.

- Discounts available on full boxes, email us for a quote.